Community


All times are UTC - 5 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Changing the default ACL?
PostPosted: Fri Jul 14, 2017 9:00 am 
Offline

Joined: Fri Jul 14, 2017 8:04 am
Posts: 1
Is there a way to change the default user ACL list and have it apply to all? I want to add a few ports for our web application that listens on 8080, etc. Its a pain to have to go through all computers and change the ACL's individually.

Along these lines, it would be really good to have a groups to assign to users. Then assign ACL rules to the group. The current system is hard to maintain consistency with access rules. I have to individually go through all computers and look at the rules. Yes, I know the ACL can be copied, but again, that is very manual. It would be much better to simply maintain a group profile and change this in one place.


Top
 Profile  
 
 Post subject: Re: Changing the default ACL?
PostPosted: Sat Aug 26, 2017 5:13 am 
Offline

Joined: Fri Aug 19, 2016 6:57 am
Posts: 19
Also, there is option to edit ACL for Default User... but I am not sure that is solution to your problem. I suppose if you don't have different users, then yes, if not... I am not sure. There are some fields that can be improves upon in both client and configuration area, but it seems there is no active development. I would like kevinz to correct me on that one :)


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 9 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: