Remote Desktop
Page 2 of 2

Author:  silviudusa [ Thu Mar 05, 2009 12:10 am ]
Post subject:  Re: Remote Desktop


Thank you for your response. It seems that I am back to square one. I still cannot connect to vista computers directly. I can wake them up but I cannot do a RDS. I am asked for credentials and after that a dialog box with 'Connecting to <ip address>' appears and it just stays there forever. As for the virtual XPPro instances, I can see a black background but it a dialog appears that tells me that the connection was interrupted. Or sometimes I can get further and log in but I get the same error with interrupted connection. However if I log in into one of the non virtual XPPro computers I can RDS to any of the above without problems. This is not an issue for me but it for my partner who's not so technically inclined, because I want to get rid of LogMeIn. If you guys want I could run a version with a log enabled so you guys can see what is going on. Thanx.

Author:  kevinz [ Thu Mar 05, 2009 7:00 am ]
Post subject:  Re: Remote Desktop

I think it's more like unstable network issue. To verify this you can try:

1. Use TCPView to monitor what protocol NeoRouter clients use finally, TCP or UDP.
Though you choose TCP P2P, it's may switch back to UDP P2P when TCP P2P failed to create, as creating UDP P2P connection is much easier than TCP P2P in terms of the network envrionment.
If in most cases it goes to UDP, relay mode is the best choice for you.

2. Check if its the RDP "Bitmap Caching" issue, check out our FAQ question 4:

KevinZ - NeoRouter team

Page 2 of 2 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group