Hi Luke,
thank you for the answer !
I have another access point in my network, but it's a Fonera2.0n which is not supported anymore by NR.
(
http://www.neorouter.com/forum/viewtopic.php?f=8&t=4686 )
I have an unused Linksys WRT54GL v1.1 but the problem will be the same, because he have not more memory.
Then i tryed to flash the Buffalo WHR-HP-G54 with the OpenWRT:
NeoRouter Free Server for OpenWrt Backfire (mipsel)
from here:
http://www.neorouter.com/downloads_nrfree.html#inaboxI was used to use some different firmware, HyperWRT, dd-WRT... but i never tryed OpenWRT.
After i flashed (using TFTP), i saw the router at 192.168.1.1
I tryed to connect to this address but without success.
I though something gone wrong and i tryed to flash it again... but the result was the same !
I though i done a mistake and flashed back to Tomato, then erased the nvram and flashed again with the OpenWRT (Neorouter server).
But again no access to the GUI.
Then I flashed the OpenWRT without NeoRouter and all was same same => no GUI.
After few search, i saw some OpenWRT have a GUI and i though some other don't have it !
Probably why this firmware only need 4Mb !
Then I flashed the router back to OpenWRT with NR Server.
I searched on the internet and as i understood, i should connect on the router using TELNET.
I'm under W7 x64 and TELNET was not working !
I searched again and found the command:
pkgmgr /iu:TelnetClient [ENTER]
pkgmgr /iu:TelnetServer [ENTER]
Now TELNET seems to work !
But while i type "TELNET 192.168.1.1", i have no answer !
Nothing connect...
Of course i have set my network card as 192.168.1.10.
How can i connect and change the settings in this OpenWRT NeoRouter server ?
I never used a firmware without GUI and will need to set the wireless network, the IP address, the NeoRouter Server, and change the router from "router" to "access point only" (i have another router in head of the network).
Thanks for your help !
Topodoco