NeoRouter http://www.neorouter.com/forum/ |
|
0.9.7 doesn't work with Tomato on Buffalo WHR-HP-g54 http://www.neorouter.com/forum/viewtopic.php?f=8&t=796 |
Page 1 of 1 |
Author: | holterdipolter [ Sat Aug 01, 2009 2:15 pm ] |
Post subject: | 0.9.7 doesn't work with Tomato on Buffalo WHR-HP-g54 |
Hi, I tried to update Neorouter Server to 0.9.7 on a Bufallo WHR-HP-g54 with tomato. The previous Version 0.9.6 worked properly. However, I'm not able to run the new version. With top command I can see Neorouter is not running, although I used the same install-procedure and formatted the jffs-folder. When I switch back to 0.9.6, neorouter runs properly again. I noticed, that the size of the new firmware is a little bit bigger than the previous version. So, is it maybe a problem of insufficient memory? Are I'm not able to run the new version on this router? Tomato shows 384kb total memory and 60kb memory free for jffs when I flash your latest firmware. Thanks, Simon |
Author: | kevinz [ Sat Aug 01, 2009 5:39 pm ] |
Post subject: | Re: 0.9.7 don't work with Tomato on Buffalo WHR-HP-g54 |
Hi Simon, Thanks for your report. Can you check this? 1. Make sure you are using the tomato version, not tomato ND. 2. After flash with the new firmware, format the jffs-folder Then you may want to restart the router, so that NeoRouter server can initialize the database and ssl certification files. These files will be stored in /jffs by default. Without them, nrserver cannot start. 3. If it does not work, please check the /jffs folder. 3 files are necessary: neorouter_0_0_1.db, server.crt and server.key. Your jffs size seems a little bit smaller, but should be good enough for at least 30 computers. Let us know if you still have problem. Thanks, KevinZ - NeoRouter team |
Author: | holterdipolter [ Sun Aug 02, 2009 6:33 am ] |
Post subject: | Re: 0.9.7 don't work with Tomato on Buffalo WHR-HP-g54 |
Hi KevinZ, ok, problem is solved. When I checked the files, I saw the Neorouter-files in the /usr/bin/ were changed from "neorouter" to "nrserver". So I just changed the scriptline, and now it works. Maybe you can change it in the manual. Thanks for your fast support, Simon ... by the way: the downloadlink for the ubuntu-client seems to be dead. Maybe you could fix it. Thanks! |
Author: | kevinz [ Sun Aug 02, 2009 8:59 am ] |
Post subject: | Re: 0.9.7 doesn't work with Tomato on Buffalo WHR-HP-g54 |
Thanks Simon, the link for the ubuntu client has been fixed. --Kevin |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |